AGA Classic 39" Total Control Repair & Service
Fully controllable electric cast-iron AGA. Each of the three cast-iron ovens and both hotplates has its own embedded electric element and can be switched on and off independently. Touchscreen control panel behind the top-left door, plus RF handset.
- Discontinued — still serviced
- Fuel: electric
- Controls: TEK PCB
- 9 models
Overview
AGA Classic 39" Total Control overview
Fully controllable electric cast-iron AGA. Each of the three cast-iron ovens and both hotplates has its own embedded electric element and can be switched on and off independently. Touchscreen control panel behind the top-left door, plus RF handset.
Configuration
- Width (in)
- 39
- Ovens
- 3
- Hotplates
- 2
- Oven Names
- roasting, baking, simmering
- Hotplate Names
- boiling plate, simmering plate
Lineup
AGA Classic 39" Total Control models
Known issues
Common AGA Classic 39" Total Control problems
What goes wrong on this series and how we fix it.
Diagnostics
AGA Classic 39" Total Control error codes
Fault and indicator codes for the AGA Classic 39" Total Control control platform.
- 002 — Com WD Fault (communication watchdog)
- 003 — Com WD Fault (communication watchdog)
- 004 — Not used
- 005 — Not used
- 006 — WD WDT Fault (watchdog timer)
- 007 — TC Ref Fault — the user panel PCB is unable to process thermocouple measurements
- 010-014 — Full power time out — the cooking zone is taking too long to reach its expected temperature. This is a safety feature, not necessarily a component failure.
- 020-024 — Thermocouple differential — the two thermocouples in a zone disagree
- 060-100 — Thermocouple open circuit
- 110-116 — Relay short circuit
- 120-124 — Cooking zone overheat error
- 130-136 — Triac fault
- 139 — User panel overheat — excessive temperatures recorded at the control panel
- 140 — Configuration key fault
- 150-156 — Relay open circuit
- 159 — RF fault — receiver not communicating with the PCB
- CE — No response from main controller
- FE — Touch panel microcontroller unresponsive or malfunctioned
- VE — Main controller firmware version incompatible
Parts
Key AGA Classic 39" Total Control parts
The parts this series actually needs — with OEM numbers and diagnostic tests.
Frequently asked questions
What are the most common AGA Classic 39" Total Control problems?
The issues we see most on the AGA Classic 39" Total Control: aGA oven door rope seal worn — heat loss, poor cooking, hot fascia; aGA oven or hotplate element failed (no heat / reduced heat); aGA full power time-out (codes 010–014) — zone too slow to reach temperature. Each has a dedicated repair guide on this site.
Do you still service the discontinued AGA Classic 39" Total Control?
Yes. Discontinued AGA series are a large part of our work — we maintain parts sourcing for legacy models and verify every part number against your serial plate.
How much does AGA Classic 39" Total Control repair cost?
Every visit starts with diagnostics and a written estimate — the diagnostic fee applies toward your repair when you proceed. We never start work without your approval.
Book your AGA repair
Same-day and next-day appointments across the Seattle–Tacoma metro. Diagnostic fee applies toward your repair.
Mon–Sun 8:00AM–8:00PM
Independent service company — not affiliated with or authorized by AGA / AGA Rangemaster (Middleby). We repair out-of-warranty AGA appliances.