AGA ERA Repair
Diagnostics, genuine/OEM parts and written warranty for the AGA ERA (AGA ERA) — service at your home across the Seattle–Tacoma metro, WA.
- Current model
- AGA ERA
Specs
AGA ERA at a glance
About this model
See AGA ERA User Guide and AGA ERA Installation USA in the local manual library.
Repairs
Common AGA ERA faults
These are inherited from the series platform — the issues we diagnose most on this model.
Diagnostics
Error codes for this model
- 002 — Com WD Fault (communication watchdog)
- 003 — Com WD Fault (communication watchdog)
- 004 — Not used
- 005 — Not used
- 006 — WD WDT Fault (watchdog timer)
- 007 — TC Ref Fault — the user panel PCB is unable to process thermocouple measurements
- 010-014 — Full power time out — the cooking zone is taking too long to reach its expected temperature. This is a safety feature, not necessarily a component failure.
- 020-024 — Thermocouple differential — the two thermocouples in a zone disagree
- 060-100 — Thermocouple open circuit
- 110-116 — Relay short circuit
- 120-124 — Cooking zone overheat error
- 130-136 — Triac fault
- 139 — User panel overheat — excessive temperatures recorded at the control panel
- 140 — Configuration key fault
- 150-156 — Relay open circuit
- 159 — RF fault — receiver not communicating with the PCB
- CE — No response from main controller
- E2 — The electronic unit is too hot
- E6 — Cookware / load fault (AGA ERA)
- Er + number — Internal technical fault that cannot be rectified by the user
- FE — Touch panel microcontroller unresponsive or malfunctioned
- (no display operation) — Over-voltage or loss of supply voltage to the range
- U400 — The range has been incorrectly connected (supply wiring fault)
- VE — Main controller firmware version incompatible
Parts
Parts we replace on the AGA ERA
Verified against your serial plate before ordering — AGA part numbers change by revision and color.
| Part | OEM numbers | Category |
|---|---|---|
| AGA customer RF handset | AE4M280526 | Control |
| AGA oven element (eR7, 2.5 kW rectangular) | AE4M280036 | Heating |
| AGA rope seal (door ropes and top plate element rope seal) | AE4M233717 | Seal |
| AGA main TEK / Tekelek PCB (complete tray) | AE4M280812 | Control |
| AGA duplex thermocouple (eR7 platform) | AE4M280732 | Sensor |
| AGA COMS communication cable (PCB to fascia) | — | Wiring |
| AGA induction generator module | — | Control |
Frequently asked questions
Where do I find the model and serial number on the AGA ERA?
On most AGA ranges the rating plate is inside the door frame or behind the lower drawer; on classic cast-iron cookers it is near the base. Have it ready when you book — we verify it before ordering parts.
How much does AGA ERA repair cost?
Every visit starts with diagnostics and a written estimate — the diagnostic fee applies toward your repair when you proceed. We never start work without your approval.
Book AGA ERA repair
Have your model and serial number ready — we verify them before ordering parts. Diagnostic fee applies toward your repair.
Mon–Sun 8:00AM–8:00PM
Independent service company — not affiliated with or authorized by AGA / AGA Rangemaster (Middleby). We repair out-of-warranty AGA appliances.